Catalyst 2960 s Express Setup

[Erik Eisen]

I'm trying to set up my 2960-S (POE) switch with the express setup. I have used the express setup on multiple 2960-G (none-POE) switches and it has workd fine. However, when I use it on the POE, and I try to enter 10.0.0.1 in my browser it askes me for a username and password, which I dont have because this is the first time this switch has been set up.

On the none-POE switch it was inside the 10.0.0.1 window that I set up the username and password. Is there some default username/password for the POE version of the switch?

I have tried resetting the switch to factory configuration, and it still asks for the username/password after I enter express setup.
All I'm trying to do is set up the IP address, name, and password.


Any help would be appreciated.
Thank you,
Erik

[leolaohoo]

Username: Cisco

Password: Cisco

[Erik Eisen]

Thank you, that did the trick!


Erik